ABATRON Super Fast BDM & JTAG

For Flash programming

To receive literature  fill in request

Abatrons BDIpro firmware uses the BDI family hardware to create a PC based flash programmer.  It can be used to program internal Flash and EEPROM or to program most types of external Flash.   Because of its high speed design and its 10/100 Ethernet interface the BDI3000 can program Flash parts at over 170K Bytes/sec (depending on the chip).     The HC12/S12 version has a standalone mode in which, on sensing power at the target,  it programs the on-chip flash and EEPROM, verifies them and gives a GO/NOGO signal after which it is ready for the next unit without requiring operator intervention or a PC to be connected to it.   Target Configuration BDI1000  (KBytes/s) BDI2000  (KBytes/s) BDI3000  (KBytes/s)   HC912B32 / HC12 Internal Flash @ 8 MHz 12 - N.A.   HCS12 Internal Flash / HCS12DP256 @ 24 MHz 33 - N.A.   HC812A4 / AMD 29F010 x 16 bit 18 - N.A.   MPC860 @ 50 MHz / AMD 29F040 x 32 bit 90 170     MPC8260 @ 40 MHz / LH 28F016 x 32 bit 22 40     MPC68360 @ 25 MHz / AMD 29F016 x 32 bit 90 160 N.A.   AT91R40008 @  66 MHz / AT49BV1614 x 16 bit 90  110     MPC8349E MDS / I28F640J3 / 16-bit N.A.   124   EVKIT 405EP / AM29LV160DB / 16-bit     180   M5329EVB / I28F160C3 / 16-bit N.A.   110   PXA250 / I28F128J3 / 32-bit     220   ARM7TDMI / SST39VF400 / 16-bit     130   MPC8560ADS / I28F640J3 / 32-bit N.A.   190   MPC8260FADS / LH28F016 / 32-bit N.A.   110   DB1100(MIPS32) / AM29LV640MH/L / 32-bit N.A.   104

To see the flash devices supported click on this link  

Software is CPU specific...........

ARM7/9TDI/11, Cortex A8 & M3,  XScale, ColdFire,    MPC5xx/8xx,  MPC744x/745x/8500,  PPC4xx/6xx/7xx/74xx/82xx/83xx, MPC52xx, Xilinx Virtex-II Pro and  MIPS32/64

HC16,   CPU32/32+,    M-CORE   --  (BDI1000 or 2000), 

HC12, HCS12  --  (BDI1000 only),  

For details of Abatron products -

Want to know more about the BDI family

Using the GCC compiler ? then they will run with the GNU Debugger

Need to use the BDM/JTAG interface as part of your ATE process and to write your own C drivers

Using the Debugger that is supplied with your compiler ? they run with:- 
CodeWarrior,  IAR,  X-Ray,  Tornado,  Accelerated Technology,  SeeCode,  CrossView,  ARM ADW/AXD